The MULTISTAR series is a universal gravure composite ink free of toluene and methyl ethyl ketone, suitable for various films. It can be widely used in the packaging of food, pharmaceutical products, hygiene products, etc.

Product uses and features

1.It is suitable for processing various printing substrates such as BOPP, PET, and nylon films.

2.It has good refit, high adhesion and composite strength, and is stable.

3.It is suitable for boiling in water at 100℃ and below. It can be used for single-component printing without a curing agent (except for nylon).

Reference color

Base colors such as F671 white, F673 White, F675 White, 678 White, F121 red, F23 Yellow, F39 Blue, F92 Black, F93 Black, S3 red, S16 Red, F262 Yellow, F523 Orange, F572 Peony, F821 purple, F79 Green, F tinted ink, colored silver, and blue mouth gold Special color samples can be prepared according to the user's requirements.

Dilution and printing viscosity

white ink: 12~15 s, color ink: 13~16 s  ※ 3#Charn CupThe ratio of printing viscosity and thinner can be adjusted accordingly according to the printing pattern, drying capacity, printing speed and printing effect.

Instructions for the Use of Curing agent

MULTISTAR series inkIt can be used for two-component purposes to enhance the performance of the ink. Curing agent addition: TCS-4394 addition amount: 1-3%

Performance improvement: Increase composite strength, temperature resistance, adhesion, etc

Disposal of old ink: Leftover ink with added curing agent should not be stored for a long time. When using it again, mix it with new ink (old ink <30%) and add the curing agent again. Pay attention to reverse adhesion.

Notes

1..Standard colors such as S3 red, S16 red and gold and silver can only be used for general packaging purposes and cannot be used for any boiling (including pasteurization), steaming or boiling purposes.

2When printing on hygroscopic films such as S3 red and S16 red nylon, there is a risk of discoloration or migration due to the influence of water. According to the post-processing and storage conditions of the product, especially for products with water on the surface, please avoid using them.

3.When mixing light colors, there is a risk of discoloration during heat sealing. It is not recommended for steaming or boiling purposes.

4.When used for PT cellophane and nylon, 3% curing agent is required.

5. There are restrictive regulations on the use of the base color ink according to the purpose. The marks indicating the applicable scope are marked before the color match number. "S" indicates the non-boiling grade, and "F" indicates the boiling grade.

Environmental protection regulations

1Complies with the requirements of regulations such as GB4806.14, GB4806.1, and GB31603;

2.Comply with the requirements of regulations such as ROHs, REACH, and EN71-3;

3.Comply with the standard QB/T2024 "Gravure Plastic Film Composite Ink". 4. This product complies with the NL rules formulated by the Japan Printing Ink Association.

Product application cases