Product uses and features

1.From general pastry applications to boiling and steaming fields, it can be used as a single component without a hardener.

2.It is used as a composite packaging material and is almost suitable for any film.

3.It has stable adhesion and refit, and the printing effect, especially the ink adhesion in the high-gloss areas, is good.

4.There is very little residual solvent in printed materials.

Reference color

3 Red S, F121 Red, F23 Yellow, F523 Orange, F572 Peony, 471 Peony, Z821 Purple, R162 Red, R181 Red, 187 Red, R235 Yellow, 237 Yellow, R262 Yellow, R39 Blue, R515 Orange, 518 Orange, R79 Green, R92 Black, R93 Black, R931 Black, R631 White, R63 Base colors such as 3 white, R675 white, R681 white, R ink thinner, R diluent, etc. can be prepared. Special color samples can be made according to user requirements.

Dilution and printing viscosity

※The addition amount should not exceed 30% and it can be mixed with the solvent of the color-matching ink for use;  white ink: 12~15 s, color ink: 13~16 s   ※ 3#Charn Cup

The ratio of printing viscosity and thinner can be adjusted accordingly according to the printing pattern, drying capacity, printing speed and printing effect.

Instructions for the Use of Curing agent

AM FINE series ink can be used for two-component purposes to improve the performance of the ink. Curing agent addition: TCS-4394 addition amount: 1-2%

Performance improvement: Increase composite strength, temperature resistance, adhesion, etc

Disposal of old ink: Leftover ink with added curing agent should not be stored for a long time. When using it again, mix it with new ink (old ink <30%) and add the curing agent again. Pay attention to reverse adhesion.

Notes

1.Standard colors such as S3 red, S16 red and gold and silver can only be used for general packaging purposes and cannot be used for any boiling (including pasteurization), steaming or boiling purposes.

2When printing on hygroscopic films such as S3 red and S16 red nylon, there is a risk of discoloration or migration due to the influence of water. According to the post-processing and storage conditions of the product, especially for products with water on the surface, please avoid using them.

3.When used for PT cellophane and nylon, 2% curing agent is required.

4. When using pure alcohol-based AC agents and adhesives, color ink may bleed color depending on the composite processing conditions (such as speed, plate roll pressure, etc.). At this point, 10% water can be added to the diluent of the adhesive or AC agent and adhesive containing 10% water can be used.

Environmental protection regulations

1Complies with the requirements of regulations such as GB4806.14, GB4806.1, and GB31603;

2.Comply with the requirements of regulations such as ROHs, REACH, and EN71-3;

3.Comply with the standard QB/T2024 "Gravure Plastic Film Composite Ink". 4. This product complies with the NL rules formulated by the Japan Printing Ink Association.

Product application cases